Coval Wood Coat is a high performance nano/covalent coating for painted or sealed wood surfaces offering improved protection from stains, acids, UV, and abrasion. This is a two part catalyzed product. Coval Wood Coat can be sprayed, rolled, or brushed on, and requires only one coat. Like all Coval products, Coval Wood Coat helps protect surfaces from graffiti, which may more easily be removed after this application.
Surfaces must clean and free of contaminates. Remove all oil, dust, grease, dirt, and other foreign material using Coval Step#1 Cleaner for Painted surfaces. Mask off areas not to be covered. In a clean container, mix equal parts of Coval Wood Coat and Coval Part B, Catalyst. This product is best applied with a HVLP (high-volumelow- pressure) spray system, with a 1.0-1.3 size tip and the pressure set at approximately 25 to 30 psi. Wood Coat may also be applied with an airless sprayer, brush, or high density ultra smooth roller. All equipment must be chemical and acetone resistant. Apply Coval Wood Coat at 4-5 mils WFT. Apply one coat. Clean up immediately with acetone.
Test: As with all Coval products, it is recommended to test for compatibility in a small area before full application.
Caution: A professional spray mask should be used with this product, as well as eye protection, rubber gloves, and coveralls.
|Uses||Protects wood surfaces from stains, UV, moisture and abrasion.Surface protection|
|Suitable surfaces||Sealed and coated wood surfaces.|
|Applications||Ideal for cabinetry, furniture, moldings, wood boat rails, or pre-finished wood floor planks prior to installation.|
|Voc"s||less than 100 g/l|
|Coverage||300-400 sq. ft. per gallon||One coat. This is a two part catalyzed product.|
|Clean-up||While soft: Acetone.||When hard: none|
|Dry time||Touch: 1 1/2 to as much as 2-4 hours Full Cure: 7 Days. Note: It is important to protect surface from water or rain for at least 5 hours after application|
|Application Method||Spray – (HVLP) 1.0-1.3 tip and 25 to 30 psi. Airless spray, brush and ultra smooth high density roller.||All equipment must be chemical and acetone resistant.|
|Other relevant Coval products||Coval Step#1 Cleaner for Painted Surfaces||Coval Part B, Catalyst|
|Ambient temp and humidity limits||45° F to 105° F working limit.||Safe Relative Humidity: 90% or less|
WARNING: Always use appropriate protection when using Coval products; including appropriate respirator,safety goggles, butyl-rubber gloves and coveralls; also, mask off or cover, all adjacent areas.