Coval Quick Seal and Enhance

Coval Quick Seal and Enhance is a fast drying sealer for porous surfaces, dry to the the touch in two minutes and recoatable in five. Coval Quick Seal and Enhance creates a breathable, stain, graffiti and acid resistant surface in concrete and other porous materials, and may be tinted to achieve stain like effects.

Coval Quick Seal and Enhance may also be used as a primer for other Coval products.

Test: As with all Coval products, it is recommended to test for compatibility in a small area, before full application.

Application

Surfaces must be clean, dry and free of waxes. Use Coval Step #1 Cleaner for Painted Surfaces and then rinse with water. Allow to dry thoroughly. Mask off all areas not to be covered, and provide adequate ventilation. Stir well, before and during application, to maintain suspension of nanoparticles. Plastic Coat is best applied with a HVLP (high-volume-low-pressure) spray system, with a 1.0-1.3 size tip and the pressure set at approximately 25 to 30 psi. Clean-up immediately with acetone.

Note:All equipment must be chemical and acetone resistant.

Caution: A professional spray mask should be used with this product, as well as eye protection, rubber gloves, and coveralls.

Coval Quick Seal and Enhance - Specifications

Uses Primarily for porous surfaces, it seals and protects from UV, corrosion, rust, salt and acid stains.Surface protection May be used as a pre-coat for Coval Concrete Coat. 
Suitable surfaces Porous surfaces such as Stone, Concrete, Slate, Stucco, Grout and Tile.
Applications
Solvent based YES  
Water based NO  
Flammable YES  
Voc"s Less than 20g/l VOCs
Coverage 150 to 500 sq ft/gal. May require as many as 4 or 5 light coats, wet-on-wet.
Clean-up While soft: Acetone. When hard: none
Dry time To touch 2 minutes, full cure in 5 minutes.
Application Method Spray Equipment must be chemical and acetone resistant.
Other relevant Coval products Coval Step#1 Cleaner for Unpainted Surfaces Coval Concrete Dye
Sheen n/a
Porosity Breathable
Flash point
Ambient temp and humidity limits 45° F to 105° F working limit. Safe Relative Humidity: 90% or less

WARNING: Always use appropriate protection when using Coval products; including appropriate respirator,safety goggles, butyl-rubber gloves and coveralls; also, mask off or cover, all adjacent areas.

Subscribe now to receive industry information, relevant news and special updates.

We respect your privacy.