Coval Multi Purpose Sealer

Coval Multi Purpose Sealer is a general purpose sealer, incorporating many of the advantages of Coval’s nano/ covalent technologies in one product. Multi Purpose Sealer creates a water resistant, but breathable surface layer in all kinds of porous materials, such as concrete, natural stone, fabric, etc. Surfaces become highly stain, humidity, UV, abrasion and graffiti resistant. This is an environmentally friendly product with zero VOCs.

Coval Multi Purpose Sealer may also be used as a primer or pre-coat for other Coval products.

Test: As with all Coval products, it is recommended to test for compatibility in a small area, before full application.

Application

Surfaces must be clean, dry and in sound condition. Remove all oil, dust, grease, dirt, loose rust and other foreign material; including all existing silicon sealers. Use Coval Step#1 Cleaner for Unpainted Surfaces. Stir carefully, both before and during application, to fully suspend particles. Mask off all areas not to be covered. Apply an even flood coat, either with a pump (deck) sprayer or by pouring; back-roll with a 3/8” nap roller, to ensure even coverage. This product requires two or more coats; re-apply wet-on-wet within 15 minutes, and repeat until surfaces are saturated. Clean-up immediately with acetone.

Note:All equipment must be chemical and acetone resistant.

Caution: A professional spray mask should be used with this product, as well as eye protection, rubber gloves, and coveralls.

Coval Multi Purpose Sealer - Specifications

Uses Primarily for porous surfaces, it seals and protects from UV, corrosion, rust, salt and acid stains.Surface protection As with all Coval products, eases removal of graffiti. 
Suitable surfaces Porous surfaces such as Stone, Concrete, Slate, Stucco, Grout and Tile.
Applications
Solvent based NO  
Water based YES  
Flammable NO  
Voc"s Zero
Coverage 200 to 600 sq ft/gal. Requires two or more coats, wet-on-wet. Re-apply until surfaces are saturated.
Clean-up While soft: Acetone. When hard: none
Dry time All Coval Molecular Coatings are dry to the touch in 2-3 hours. Full cure 7 days. Note: It is important to protect surface from water or rain for at least 5 hours after application.
Application Method May be sprayed, brushed rolled or applied by dipping. Equipment must be chemical and acetone resistant.
Other relevant Coval products Coval Step #1 Cleaner for Unpainted Surfaces
Sheen n/a
Porosity Breathable
Flash point
Ambient temp and humidity limits 45° F to 105° F working limit. Safe Relative Humidity: 90% or less

WARNING: Always use appropriate protection when using Coval products; including appropriate respirator,safety goggles, butyl-rubber gloves and coveralls; also, mask off or cover, all adjacent areas.

Subscribe now to receive industry information, relevant news and special updates.

We respect your privacy.